Recent content by ekim

I think there are two possible places to put a gauge. On the valve, and on the top. The valve appears to be a small NPT fitting. The top seems to be something sealed with an O-ring. Is one preferred over another?

When I looked for long radius sweep elbows all that I found were DW fittings rated for something like 5 PSI. Are long radius sweeps common for pressure applications?

I could hear the air being pulled in. Found a wet plug on the filter valve (I guess a plug for a pressure gauge?) and a water "bubble" on the PVC pipe coming out of the pump. Addressing these seems to have fixed the problem. Thank you for the quick reply and excellent debugging suggestions.

When my pump shuts off I get lots of bubbles in the system. It seems as if the filter is draining out into the pool. If I leave the pump running non-stop for a few days, I have zero bubbles in the pump housing. There are no check valves in the system that I can see. Should the filter hold...

Is that success? Something you wrapped in plastic must be the problem. Now you just need to narrow it down if you wrapped multiple things right?

I found this excellent description about using the sock method: As a follow up, specific for SWG pools, should the SWG generator be off for 24 hours if this method is used? More generally, is there a write-up that discusses best practices for adding chemicals in an SWG pool?

Thanks for the quick replies. I got 5 bags in and the brushing isn't bad at all. I poured them around the entire pool. I think I'm just going to dump the next 5 right into the deep end - any reason to not do that?

What is the difference between softener salt and pool salt. From what I can tell the water softener is bigger crystals - does that mean it's harder to dissolve? I have to put ~10 bags in. $90 for pool salt vs $70 for softener salt. If the pool salt will save me a few hours of brushing to get...

I found the manual and it showed it as a removable part, so I removed it. It was loud - I thought it might shatter, but it came out whole. Now, to fix - the manual has part number : S200EB, but online I seen to find SX200EB more easily. Is there a place to cross reference Hayward numbers?

I tried to cut a view port into the base, but I picked a bad spot so I couldn't see anything. I pulled it apart, put it up on blocks, filled it with water and found the leak from the drain pipe. I can't tell for sure if it's coming from the pipe or where it's attached to the filter. Does this...