Recent content by cwinn

Yes, the JVA is assigned and working. The Cleaner is assigned to AUX3 and the JVA is plugged in to that port. I am able to control the pool (pump, VSP, lights, Aquapure and JVA) from the app or from the panel/board when in service mode. Thanks again!

The only item plugged into the JVA relays (right hand side) is the single JVA that I have and it is on the CLEANER spot. With nothing plugged in the INTAKE or RETURN I assume that these can or should be set to "No Assignment"? Attached is a pic of the original board before replacing with the...

I found the manual, I have some reading to do. Thanks

Thanks for the prompt reply, and I hate being slow on the uptake, but how do I access the menu to assign JVAs? I do not see that option. Correct, I just have a pool. The JVA is plugged in to the cleaner socket (between return and solar) It is not assigned to an aux that I am aware of.

Hello, I had an Aqualink PDA system installed by the builder in 2017. The screen on the PDA over the last few years got darker and darker and is/was almost un-readable unless in direct sunlight. I ordered and installed the iAqualink 3.0 upgrade kit (from Marina pools and Spa) today...

As mentioned, it should be under warranty either through your PB or through Jandy directly. I had the exact same error codes (alternating 125/194), however my cell was ~4 years old. I purchased a new cell from Marina pools, installed and problem solved. I dissembled the problematic cell and...

Thanks for the replies/info. Watering, fertilizer, a little rain and its showing improvement, looks like it should be back to normal in a few days.

hello, Long time reader and first time poster. I really enjoy reading and learning everything I can from this site. So this is starting year 3 of pool ownership and I think I’m getting the hang of it. We had some major issues with our pool plaster after initial fill but that is a “story”...