Recent content by cranbiz

It's one of these. https://www.amazon.com/A2Z-Ozone-Inch-Check-Valve/dp/B001IYJ18O

The ozone generator is probably shot. They don't last more than 3-5 years. Pumps should run when turned on. Pump 2 does this, pump 1 does not. A quick test will be to reverse the motors for pump 1&2 as they should both be single speed pumps. Does the problem follow the pump? If it follows the...

That's a GFCI breaker. If you are replacing a GFCI breaker, yes, you need the neutral pigtail. That looks like a Cutler Hammer BR series and if it is, Home Depot sells it for $130. Which panel is that from?

They should be interchangeable. The close parallel terminals are the same polarity on the capacitor.

Your tub got cloudy because the Frog was out of or very low on sanitizer. It's common with Frog because most people don't check it regularly. That's one issue with Frog that you won't get following TFT's system. You monitor your tub using TFT daily, so you are always aware of your sanitizer levels.

Frog is releasing sanitizer and treating the water thru the mineral cartridge anytime there is water flowing. The cartridges have a series of small holes that release amounts based on how many holes are exposed. My Artesian is plumbed to the circulation pump and will release chlorine when it...

Have you tried calling LPI customer support? (423) 349-2900 Honestly, I would be surprised if you actually get someone to help there but it's always worth a shot. Post up the size of that jet, I'm sure we can find it somewhere. LPI is buying that from either CMP or Waterway. They don't make...

I went to the Ahhsome website. The written instructions were very easy to find so I'm not sure where A.O. was looking. As far as the video's, I agree with A.O.. If you looked hard enough, you can actually find the video where you are told 1 tsp per 125 gal of water but it's not until over 6...

Looking forward to watching this one come back from the dead.

Do you have a good cover? What is the temp set point and does the tub get to that point? Do you have a circulation pump? What is the filter cycle set for? Normally one would set it for 2 hours a cycle, twice a day. Setting F2.

It is most likely a Dreammaker tub. The Gecko IN-YJ-2 control box cannot be retrofitted for an external heater. It is strictly a heat recovery system. If you want to wire in an external heater, I would recommend replacing the Gecko box with a Balboa VS501 or a BP7. Both of those setups come with...

We are going to need pictures of your spa pack, the wiring diagram usually found on the inside cover and of the equipment area. Tagging @RDspaguy for help once we get the pictures.

3 ohms on the heater is not good. It should be around 14 ohms.

Forget the built in salt system, go with a drape in unit like the Saltron Mini if you want a salt system.

The Frog system does work and it's easy to maintain, it's expensive to use. Some don't believe it's the best system and that is probably true. It's not "smart" it's time delayed chemical disbursement. Dichlor and liquid chloring is a better system of sanitization. It works but it requires more...