Recent content by Conman

Hello Jim Thank you for the response . I do not have any schedules set. Can I clear the schedules? I'm working on it today I noticed the control panel on my heater is no longer lighting . It displays the temp when the spa fires up. There are no service leds or any led lit for pool spa or...

Hello I need help with my automation . I have a compool to easy touch conversion . The spa actuator valve on the pump side goes back to spa mode in the AM start up. It is then only returning water from the spa back to the filter. The top button on my indoor controller is for spa mode and is on...

Thanks Rocket

after searching i found the answer Thanks Any way

Today I installed four new pool lights I also bought a new GFCI breaker. When I turn on the lights it trips the GFCI breaker .The old lights had no gfci breaker I have an easy touch controller. I tried just the spa light tripped breaker same with pool lights . With my regular 15 amp breaker no...

I have a Pentair Mini Max pool heater for my pool and spa with an EZ temp control panel . I switch from com pool 3800 a few years ago . This year I opened the pool and the spa control is not working right I have to turn the heater on in either spa or pool for it to fire up but when I shut the...

Has anyone tried the Pentair Starb guard main drain covers . I have the same problem with an Aquabot Turbo 2. I also have a bottom cover with a wheel built into it . That gets stuck too.

Any new ideasI have the same problem with my aqua bot I also tried the the bottom cover for the bot with wheels still getting stuck Ive read good and bad reviews of the Uni Bridge Cover still trying to find a pentair low profilke cover>

cord stopper is not avaiable

I just order 3 pool lights and a new spa light. My question is should I drain my pool to let the water out of the conduit. Can i just seal them with an underwater silcone or epoxy. Or just pull the new lights in the conduit without sealing the conduit. If I dont drain it how can I remove the...

anty thoughts

One of my lights flooded over the winter and stained the plaster how can i remove the stain

I want to change all of my SAM lights to LED color inteli bright lights. My question is when I replace the lights do I have to replace the silicone that they sealed the conduits with. I don't want to drain the pool after I just opened it and filled. My J-boxes are 3 feet higher than the water...

The Plaster Co replaced my bottom drain covers in the deep end of my poolI I think he said the old ones where not up to code . The problem is the covers are much higher than my old covers and my aquabot turbo gets stuck on the covers Im looking for a lower profile cover for pentair drains if...

Bump