Recent content by clem1985

I think the timer on the unit is 2hr increments so I'll try reducing my it by 2 at a time and monitor

So, I have a 6100gal above ground pool. Recently added a Intex swg. First season using one. It's been great so far. Current CYA of 55-60. Ph 7.6. pool math app says I should be shooting for 7fc. I've been measuring almost daily for the last 2 weeks just to get a baseline of where the FC levels...

Thank you, that was very helpful

Is it ok once I receive my SWG generator to go ahead and start running or just stick with bleach until it warms up more consistently? The temp has a been pretty cold the last week. If not can I go ahead and add the salt anyways? Currently adding stabilizer in a sock to the pool.

Ok, great thanks for the reply. Another question. Do you raise the fc initially by using bleach to desired fc level before running swg?

Guys I have just set a new replacement Above ground 18ft pool. For last several years I have followed tfp recommendations for adding chlorine and slamming etc. decided this year to try my hand at SWG. The question: is the purpose of the SWG to makeup for fc loss due to sun heat etc. ? So let's...

So today since we had all the rain and water level was higher. I decided to vacuum to waste the dead algae since it would keep coming back after vacuuming and brushing and not getting filtered out. We'll see if this helps.

That's a good point. I have been vacuuming daily and brushing. And dead grey algae keeps coming back on the floor. So maybe it's just passing through the filter? It's been a while since I've posted here. So my signature is not updated. I have since upgraded the filter to a much improved...

Background: opened pool to a green swamp. Been slamming for about a month. Pool passes OCT. CC .5 or less. What I have been battling for a while now is just a hazy water. It has been clear enough to see the bottom. Just not crystal clear. This brings me to today. This morning after confirming no...

Thanks to this forum for helping me get my pool ready for this summer! Got to finally take a sim with the kiddos! Water was great, felt soft, no heavy chemical smell. Pool has been holding at 10fc at 50cya every day. Water is clear with no algae in sight!

So, I retested my CYA, I didn't think it would drop that much, but boy it did, since I did a partial drain and refill. I had to fill the r0013 solution all the way to the top have the black dot dissappear. There is not even a ppm mark for that. Is it 20ppm? I'm definitely going to have to raise...

How long of a time window does a owner have once the fc drops below fc maintenance ppm before algae could cause a problem or even start to grow. For example cya of 50 has a target fc of 6-8ppm, over the course of the day the fc naturally drops down to 4ppm. It needs to be brought back up to...

Drained the water off below the skimmer, since I needed to replace a leaking gasket,but also from the excessive rain. So, once refilled to normal water level I'll recheck the cya from water replacement. It was 50 hopefully it didn't drop to much

I have experienced heavy rains in my area for the last week and a half, and supposed to continue till the end of the week. Should SLAM be performed because of that. Or just maintain. I'm also going to need to drain some water