Recent content by cdclw

waterfall 2.5hp, infinity edge 1.5hp , jet pump 2.5hp single-speed, I'm not in CA

My 15yr old pumps all died this year, probably due to wet weather (uncovered). I need to replace 2x2.5 hp, 1x1.5 hp; single-speed, square-flange Jandy impeller. Old were Century Centurion. Is there any motors that are better than others, or should I just go with warranty length?

well that's a great and should have been obvious idea.. will try, thanks PG

Thanks James! guess i have to find the correct jumper...or, disconnect power to the entire board? guess it doesn't matter if Im not using it.

Holding Salinity button for 5secs is supposed to disable the beep, but doesn't. The SWG hasn't worked for some time, I add chlorine. Anyone have tricks for disabling annoying tone... permanent is fine

ajw22 -- a solar cover, 18x36.. irregular shape pool... I bought a new "med blue" cover, would sell it

My pool is on South side and I don't like the normal "med blue" color, because it reflects too much bright light.. My pebble tec is darker and I like the deep, dark blue color. If any of you have a blue/black cover, can you send a pic of the pool? I can't be the only one that doesn't like the...

Those are red and black... do i connect them (red & black)?

Yeah! Jandy aqualink manual has T/S for heater.. "From the green 10 pin terminal bar of the AquaLink RS Bezel, remove, and twist together the two heater wires; does the heater fire?" giving that a shot (not shock, hopefully...)

Thanks Paul, heater transformer is probably good... using Jandy heater troubleshooting manual.. I don't have 24 VAC, or 12VAC across heater transformer because I don't have the voltage coming into the heater from the main pool circuit panel... any ideas in there? the rest of the system is...

is transformer a high fail item?

Paul, you are correct, no connection to those wires.... troubleshooting

Thanks much Paul! will do