Recent content by calculus

Yes, the VSF Pump is controlled by automation. The display on the pump is controlled by automation unless is put the Pentair automation panel on Service.

Hi, I had a power outage at my house and now my Pump is turning On and Off by itself. I already turned off the breaker for five minutes and reset the scheduling. The Pump is still turning On and Off by itself. I can’t identify the problem. Any suggestions?

So, even though that they are frost proof or resistant, they can crack?

Hi, I'm renovating my pool and I'm thinking of putting Glass Tile on the Spa. I live in the Jacksonville, FL area. I heard that Glass Tiles tend to crack with time. I have been reading that the Glass Tiles don't crack as long as they are frost proof. I also read that there is a difference...

Hi, I have two (2) electronic valves that are not turning. Therefore, there is no circulation in the pool. There is only circulation in the Spa. The valve that controls the suction portion is working fine. However, the one returning water to the pool (pressure) are not working. At least that's...

Fuel sources: Propane and Electricity The heater will be placed outside.

Hi, I have a small underground indoor pool, 14k gallons. I want to find the best energy efficient way to heat the pool. The water is always cold. Any suggestions?

Gotcha! I will try it Thanks for your response.

Hi mknauss, Thanks for your response. Yes! I’m new to the forum and this pool thing :) I will work on my signature ? You mean create a Feature Circuit to ramp up the RPM for the in-floor cleaners? And you are saying, then run the pump on a low RPM for 3-4 hours, how much on that RPM, 1k or lower?

Hi mas985, Thanks for your response. Yes, I meant Intellichlor. The Easy Touch panel says that my pool SWG is, 30%. The actual cell says is, 40%. Yes, I do have an in-floor cleaner. What would you recommend on pump running time and RPM’s? Should I put the chlorinator to 100%? Thanks

I chlorinate the pool with the IntelliFlo salt cell.

Hello, I bought an Intelliflo VSF and I want to be as energy efficient as possible, without compromising the water. My pool is 14,000 gallons and is an indoor lap pool. Right now, I'm running the pump for 12 hours. The first 3 hours on high and the rest on low. It's running at 1,500 RPM. What...