Today my 2hp Hayward Northstar finally died. It won’t start and interestingly this causes rather loud breaker buzz. The pump itself seems to be quiet but it does get warm. Can anything be said about the failure from these symptoms? A failed capacitor would cause the pump to hum I’d think, not the breaker.
Pump dead
- Thread starter gvl
- Start date
- Jul 21, 2013
- 66,410
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
I think that’s it, the needle on my ohm meter doesn’t move. The shaft spins freely.
Hmm, having difficulty locating my motor part# in the cross-reference document which is 193688. Looks like the motor uses a single run capacitor, what I have is 55mF/370V, I suspect it’s not original looking at the cap mfg. date. The parts cross reference lists 50mF as the largest run cap and dimensions/form match what I have, so chances are they slapped 55 instead of 50 which is probably ok, but it would be good to find out the original spec.