I have 1.5 inch plumbing and I’m going to be replumbing some of my equipment in the spring when I get a new SWG and VSP. Since I’m going through the trouble I was thinking I may want to revamp all the plumbing. I’ll attach a picture but on the suction side I have 3 ball valves and I know at least one of them didn’t completely seal anymore. I also have 3 way Jandy valve and check valve for the heater, should I replace all of them? I assume at some point they wear out? My question is what valves should I replace these with and where would you suggest I purchase them? I’m not looking to spend tons of money but not looking to cheap out either. Should I just replace like for like or are there better options for my setup? Thank you in advance!