No power to heater?

[daddyslim6]

2nd summer with our pool and def still pool noobs in Georgia. Always appreciate the expert advice here. Had some bad storms the past few days. Not sure if we got struck by lightning or what, but turned on our Pentair Sta Rite 333k heater to our hot tub tonight and our EasyTouch showed it was on, but the heater never came on. Walked over to the heater and there were no lights on the heater. Nothing! However, the easytouch board showed heater was actually on but obviously never kicked on and had no power. Please tell me this thing isn’t shot and just needs to somehow be reset??

 

[daddyslim6]

2nd summer with our pool and def still pool noobs in Georgia. Always appreciate the expert advice here. Had some bad storms the past few days. Not sure if we got struck by lightning or what, but turned on our Pentair Sta Rite 333k heater to our hot tub tonight and our EasyTouch showed it was on, but the heater never came on. Walked over to the heater and there were no lights on the heater. Nothing! However, the easytouch board showed heater was actually on but obviously never kicked on and had no power. Please tell me this thing isn’t shot and just needs to somehow be reset?

 

[mknauss]

Check the wiring for the Firemans Switch.

Hayward H-Series Heaters - Further Reading

www.troublefreepool.com

 

[ajw22]

This link is for your MasterTemp heater…

Pentair MasterTemp Heaters - Further Reading

www.troublefreepool.com

 

[mknauss]

Please update your signature -- it shows a Hayward heater.

 

[PoolGate]

Check the breaker for the heater.

 

[daddyslim6]

Please update your signature -- it shows a Hayward heater.

Yes sir will work on that. Not sure why I put Hayward when I set up my account!

 

[daddyslim6]

Check the breaker for the heater.

Reset all the breakers in my ET8. Pump reset but heater is showing no sign of life.

 

[daddyslim6]

This link is for your MasterTemp heater…

Pentair MasterTemp Heaters - Further Reading

www.troublefreepool.com

Thank you for the link. Will it show me how to reset the switch and will I need to light the pilot light too “if” I get power back on?

 

[ajw22]

There is no switch to reset and the MasterTemp does not have a pilot light. It has an igniter that glows for each cycle.

 

[1poolman1]

Reset all the breakers in my ET8. Pump reset but heater is showing no sign of life.

If the heater is controlled through the fireman's switch, it will not become "active" until the automation turns it on. Try turning the heater on in the EasyTouch, it should come to life.
If it does, be sure to put it in pool or spa mode (doesn't matter which) and set the temperature to 104. Then, unless there is an issue, you should not have to touch the heater again. The automation will turn it off again when done.