Hello hive mind.
I'm having two issues with my pool config and I am not sure how to resolve or if they are related.
1. My Hayward VSP pump stops after about 15 minutes saying no flow detected. I've tried a backwash, re-priming, restarting Omnilogic so either a sensor issue or a config issue. I can't see any pressure loss or water loss at all.
2. My Sense and Dispense no longer shows pH or ORP readings on the display, but in Service mode it shows the pH value. I can't find the ORP reading in Service mode.
I have checked the config as best as I can, and all seems to be connected, but I can't be 100% certain.
Problem started after I deleted the light config from the Spa configuration to fix my lights timing out (solution from a previous thread on this forum).
My questions are:
a. If my flow sensor has failed, then will that impact the S&D working? or vice versa?
b. How can I check if the S&D configuration has become corrupt?
I'm running MSP 4.3.1 (latest release).
Any ideas gratefully received.
many thanks
I'm having two issues with my pool config and I am not sure how to resolve or if they are related.
1. My Hayward VSP pump stops after about 15 minutes saying no flow detected. I've tried a backwash, re-priming, restarting Omnilogic so either a sensor issue or a config issue. I can't see any pressure loss or water loss at all.
2. My Sense and Dispense no longer shows pH or ORP readings on the display, but in Service mode it shows the pH value. I can't find the ORP reading in Service mode.
I have checked the config as best as I can, and all seems to be connected, but I can't be 100% certain.
Problem started after I deleted the light config from the Spa configuration to fix my lights timing out (solution from a previous thread on this forum).
My questions are:
a. If my flow sensor has failed, then will that impact the S&D working? or vice versa?
b. How can I check if the S&D configuration has become corrupt?
I'm running MSP 4.3.1 (latest release).
Any ideas gratefully received.
many thanks