Hello All...after reviewing the posts from others that have had this issue (the problem is virtually identical to the one newmaac had in May of 2014 - Jandy aqualink RS not turning off .) Currently, I have to manually flip the breaker on and off to run the system. After switching the breaker on, the system will go through the program, switching to low speed when it is time, but won't shut off at the end (it goes back to high speed until I switch the breaker back to off). Both controls (indoor and outdoor) will not allow the pump to be shut off. I figured a new pump relay would solve the problem (used the information from FGrankw1's post - Is it farily easy to replace pump relay switch .) But, unfortunately, replacing the relay (upper left in the image) didn't make any difference. Is it possible I used the wrong breaker or got a bad one? Or is there something else I should be checking? I appreciate any assistance that can be given! -Dave