Hey everyone, I have a Pentair UltraTemp 120 H/C (460935). Last night it shut down at about 95-96 when it hit target temp. I wanted the water a bit warmer so I turned up the temperature to 99 but the heat pump never kicked back on. I know there has two be a 5 degree difference between the hot and cold temp setting, thought I might be mistaken at it was more like 6-7 degree difference. turned it down to 97....still nothing....water temp dropped down 94 and the heat pump still didn't kick on. I adjusted the water temperature offset both -2 and +2 and it didn't make a difference. I turned off the "has cooling", still nothing. When I would turn on the "has cooling" it would set the cool point to default and kick on to cool the water. Water temp dropped to 94 and still the heat pump didn't kick on??? any ideas why? I'm not at home now, but i'll have the wife check to see if the heat pump is on once the pump kicks on and starts its daily thing.
I had an issue that was fixed by the PB where a temp sensor was bad and not letting the heat kick on, just the cool mode.
I don't have a spa, but see spa settings in the menu. Not sure if that could fudge something?
I will be contacted the PB at some point, but would like to figure it out myself/with you guys first if possible or at least know what I am going into when I call the PB.
Thanks!
I had an issue that was fixed by the PB where a temp sensor was bad and not letting the heat kick on, just the cool mode.
I don't have a spa, but see spa settings in the menu. Not sure if that could fudge something?
I will be contacted the PB at some point, but would like to figure it out myself/with you guys first if possible or at least know what I am going into when I call the PB.
Thanks!