So I checked the chlorine in my pool today since we recently had a bunch of rain. Big surprise, I have none! Go check the hayward unit and it says salt 0 and check cell. I check salt and I have 3400ppm. So I know I have salt. I tried to reset the unit and salt still stays at zero. I really hope the cell didn’t fail after 4 years. But it could have. Any thoughts on the 0 reading. I’m going to clean the cell when my wife gets back from the pool store getting chlorine and acid. Thanks in advance for any advice.
Think my cell took a Crud!!
- Thread starter curtisimo81
- Start date
- Jul 3, 2013
- 9,027
- Pool Size
- 15000
- Surface
- Vinyl
- Chlorine
- Salt Water Generator
- SWG Type
- CircuPool SJ-40
- May 3, 2014
- 62,819
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
Hayward Aquarite SWG - Further Reading
www.troublefreepool.com
Review the article to see if anything helps.
Until JamesW stops by, here are the instructions he gave me. He'll likely ask the same stuff.
www.troublefreepool.com
Failing T-15 Cell?
I have a Hayward AquaRite SWG and Hayward T-Cell-15. Today I noticed no flow warning light. I am running my VSP at 1725 rpm. Normally, that is fast enough to engage the flow switch. I backflushed my sand filter and the resulting flow rate was enough for the SWG to run. At that point, I decided...
www.troublefreepool.com
Thank you all for the help. Unfortunately there are no places here that I can bring the cell To have it tested. Leslie‘s says they do it but their tester is not working at the moment. So I guess I’m going to try to figure it out myself. I cleaned it and salt is still reading zero and the check cell light is on and low salt. Thanks again for your help!