Hayward Goldline Aqualogic issue?

[Hammer49]

Has anyone experienced the Aqualogic system actually turning the pump on without being programmed to do so?

 

[JamesW]

Maybe freeze control if the water temperature is not correct?

 

[Hammer49]

Maybe freeze control if the water temperature is not correct?

Thanks for the recommendation. I checked the water temp and it is in the 80’s. This is obviously a strange problem. There’s power to the unit at all times, but it’s like the control board keeps changing. Perhaps a bad relay switch?

 

[JamesW]

Is the water temperature reading from the system accurate with the actual water temperature?

How old is the system?

What are the programmed run times?

When does the pump come on and how long does it stay on?

Sometimes the clocks stop working properly. Is the clock accurate?

 

[Hammer49]

Is the water temperature reading from the system accurate with the actual water temperature?

How old is the system?

What are the programmed run times?

When does the pump come on and how long does it stay on?

Sometimes the clocks stop working properly. Is the clock accurate?

Thanks again for the guidance.

The water temperature is displayed accurately.

The system was installed in 2007 but the AquaLogic board is a replacement board. The original board was fried by lightning last year. The new one was purchased used. It seemed to work fine until recently, but I know things can change.

The pump stays on for varying lengths of time. Sometimes a few minutes and others close to an hour.

The clock does appear to be keeping accurate time.