Last October we converted our pool to salt and had an iChlor30 installed. After only a few months, the flow/sensor switch was replaced 2 times and then the unit started leaking. Pentair replaced the unit.
The new unit Is only a few months old and has had it’s switch replaced once already.
This morning on power up, the unit is flashing a red low salt light and there is no display at all in the output display window. It also won’t enter the diagnostic mode. It was only a red salt light last time. So is this another bad switch or something more?
Time to call Pentair for a work order.
Should I be thinking of another type/model as a replacement or do all SWCG’s have these continual problems?
The new unit Is only a few months old and has had it’s switch replaced once already.
This morning on power up, the unit is flashing a red low salt light and there is no display at all in the output display window. It also won’t enter the diagnostic mode. It was only a red salt light last time. So is this another bad switch or something more?
Time to call Pentair for a work order.
Should I be thinking of another type/model as a replacement or do all SWCG’s have these continual problems?