Where to put a SWG in my set up.

[jkhobbs05]

any recommendations on how to get a SWG in with this configuration of piping? If I remove tablet feeder that is a 10.5 inch gap. The SWG (circupool core) needs 7.5 inch gap.
Is only way cutting out the entire bend and making it longer?
Thanks

 

[1poolman1]

any recommendations on how to get a SWG in with this configuration of piping? If I remove tablet feeder that is a 10.5 inch gap. The SWG (circupool core) needs 7.5 inch gap.
Is only way cutting out the entire bend and making it longer?
Thanks

Remove tab feeder, replace with SWG. Easy.

 

[jkhobbs05]

Remove tab feeder, replace with SWG. Easy.

Is there an issue with the 10.5 inch gap the tab feeder takes with the 7.5 inch gap for the SWG?

 

[markayash]

I would remove and redo that whole section anyway so you can make it cleaner and longer if you want.

 

[Texas Splash]

While my SWG is the RJ-45, I basically did the same. You can cut or add PVC as needed to accomoidate the space required for your Core model.

Circupool RJ-45 Plus Install

This weekend I finally installed my RJ-45. I've been stalling on this for a long time, but the 2020 COVID-19 pandemic and resulting chlorine shortage finally pushed me over the edge. Plus, it was simply time. The Circupool Installation and Operation Guide is quite good, but here are some...

www.troublefreepool.com

 

[trivetman]

Go vertical configuration