I've got an Intex XTR 12x24 that I'm going to be installing PVC plumbing on and a Pentair 1.5hp VS pump and good sized Pentair cartridge filter to go with it. The pool is rated at 52 inches deep throughout but realistically is more like 48 inches. The size of the pump is probably overkill, I know, but I wanted to have a really powerful pump that I could run at a low speed that would still get lots of turnover. I also did some home testing and verified on a state-wide climatology site that winds primarily come from the south to south-east during pool season where I'm at, at least over the past 20 years or so. The pool is almost perfectly positioned North to South length-wise.
I know that "current" (no pun intended
) thought is to make your water into a vortex of sorts with your returns but for a pool this size and shape wouldn't it be at least just as good to push the water directly across the pool from the corners and center from the returns on one side while having it pulled across the pool with the intake and skimmer doing their thing on the opposite? With the corners being the generally weak spots for water movement this setup would have all 4 of them covered. I have a wide-mouth Hayward skimmer and adjustable Hayward 1 inch returns and a an additional 1 inch for the intake with a grate that screws over it. I will be using 1.5 inch PVC sch 40 to connect the the intake and skimmer to a Pentair 3 way, then use 2 inch PVC to the pump from that. A similar setup will be done with 2 inch and 1.5 inch PVC sch40 from the filter to the returns. Looking for some feedback or flaws in my logic on this. Or if you have any ideas on better placement for any of these components including direction of return nozzles I'd be grateful to learn about that too.
Some of my other thoughts were to the size of the return openings and if 1 inch would be too big, at least for the returns. Maybe smaller diameter for more pressure to push the water across the pool? Or maybe only use two returns? Thanks!
I know that "current" (no pun intended
) thought is to make your water into a vortex of sorts with your returns but for a pool this size and shape wouldn't it be at least just as good to push the water directly across the pool from the corners and center from the returns on one side while having it pulled across the pool with the intake and skimmer doing their thing on the opposite? With the corners being the generally weak spots for water movement this setup would have all 4 of them covered. I have a wide-mouth Hayward skimmer and adjustable Hayward 1 inch returns and a an additional 1 inch for the intake with a grate that screws over it. I will be using 1.5 inch PVC sch 40 to connect the the intake and skimmer to a Pentair 3 way, then use 2 inch PVC to the pump from that. A similar setup will be done with 2 inch and 1.5 inch PVC sch40 from the filter to the returns. Looking for some feedback or flaws in my logic on this. Or if you have any ideas on better placement for any of these components including direction of return nozzles I'd be grateful to learn about that too.Some of my other thoughts were to the size of the return openings and if 1 inch would be too big, at least for the returns. Maybe smaller diameter for more pressure to push the water across the pool? Or maybe only use two returns? Thanks!
Last edited:
I just knew where I wanted my equipment & skimmer to be positioned for aesthetic & practical purposes. I have a round pool so the toilet bowl effect tends to take care of things. I am also 1/2 buried so an entire 1/2 of the circle was out of the equation for skimmer & jets