Volt Meter to Check Salt Cell?

Bama Rambler

Mod Squad
TFP Expert
Bronze Supporter
LifeTime Supporter
Jun 22, 2009
24,208
SouthWest Alabama
It doesn't have to be a Fluke as that's a brand name. A good multimeter that will measure DC volts and amps is what you should look for. I have a clamp-on that'll measure DC amps. Those are the best but are a little expensive.
 

Aquatica

Platinum Supporter
LifeTime Supporter
Jun 26, 2010
514
Nassau, Bahamas
Bama Rambler said:
It doesn't have to be a Fluke as that's a brand name. A good multimeter that will measure DC volts and amps is what you should look for. I have a clamp-on that'll measure DC amps. Those are the best but are a little expensive.

Thanks Dave. so I need a multimeter. Then I need to figure how to test the cell with it. I usually just use a replacement test cell which I know works but we only have hayward cells. sometimes need to test other makes.
 

Strannik

TFP Expert
LifeTime Supporter
Jul 24, 2007
874
Brisbane, Australia
yeah, doesn't have to be a Fluke, just any good clamp on
as long as it can measure DC up until 50 amps you should be fine for any of the residential units

to test it you make sure the salinity is within the recommended range, then crank up unit to the max and measure voltage and current. if the voltage is at the max and current is lower than normal, then it's highly likely the cell is bad.
 

Pool Clown

In The Industry
Sep 5, 2008
2,191
Silicon Valley, CA
I use my inductive (clamp on) meter to measure amps on a cell while running. On Aquapure 1400 cells, i get about 7 amps hooked on to the green wire. inductive meters only work if you can get it on one wire. So that usually means you have to remove the cover on the box, and grab the cell wire on the other(box) side of the plug.
 

mas985

TFP Expert
LifeTime Supporter
May 3, 2007
14,735
Pleasanton, CA
Pool Size
20000
Surface
Plaster
Chlorine
Salt Water Generator
Amps cannot be measured directly but can be measured as a voltage across a known low value resistor in series with the circuit. With a known voltage and resistance the current can then be calculated using Ohms law (I=V/R). This is the same way that some multi-meters measure amps (i.e. non-induction type) and I suspect that SWGs use this same technique because it is both simple and cheap to implement. I doubt they would use an induction coil. But either way, the measurement should be accurate as long as everything is calibrated.

So the amps and voltage readout of a SWG should give a reasonable indication of cell performance. However, the salt level readout is definitely a calculation and in addition to amps and volts, requires a temperature measurement to get an accurate salt level although not all SWGs use temperature in the calculation. SWGs that don't use temperature in the salt calculation tend to have high error at low temps. But this type of salt measurement is a basic TDS measurement so anything that increases conductivity such as calcium and magnesium will inflate the salt measurement. Temperature will also increase conductivity which is why it needs to be compensated for when calculating the salt level.
 

Enjoying this content?

Support TFP with a donation.

Give Support
Thread Status
Hello , This is an inactive thread. Any new postings here are unlikely to be seen or responded to by other members. You will get much more visibility by Starting A New Thread