I just had the SuperFlo variable speed installed with communication cable and I had an existing GL-235 (Aquastar II) controller controlling the solar valves. The installer and I couldn't figure out where to hookup the communication cable to the GL-235 to tell the pump to engage higher speed when solar heating is going on. There are booster pump screw terminals, but the wiring diagram seems to imply those are high voltage.
I've seen some references on this forum where the combination is compatible, but I didn't see what they did to wire them up. Can someone point me in the right direction?
Thanks
I've seen some references on this forum where the combination is compatible, but I didn't see what they did to wire them up. Can someone point me in the right direction?
Thanks