Hayward Gold Line Controls question
I have read through other threads before my first post here. I have a "solar sensor open" along wit the red check system light. If I scroll through with the arrow the sensors appear to be giving the right readings on the readout. Just now I took a new sensor and connected it to each location on the board and nothing changed other than the temps of the temporary sensor. The freeze protection did click on when I swapped out the air temp sensor. Nothing changed when I connected it to the water temperature sensor location. I do not have or know how to use a multimeter but I believe I essentially confirmed the sensors are good by the correct readings and temporarily swapping in the new sensor. Any suggestions would be greatly appreciated by this noob!
I have read through other threads before my first post here. I have a "solar sensor open" along wit the red check system light. If I scroll through with the arrow the sensors appear to be giving the right readings on the readout. Just now I took a new sensor and connected it to each location on the board and nothing changed other than the temps of the temporary sensor. The freeze protection did click on when I swapped out the air temp sensor. Nothing changed when I connected it to the water temperature sensor location. I do not have or know how to use a multimeter but I believe I essentially confirmed the sensors are good by the correct readings and temporarily swapping in the new sensor. Any suggestions would be greatly appreciated by this noob!