- Apr 6, 2020
- 48
- Pool Size
- 18550
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Hayward Aqua Rite (T-9)
Hello-
I'm having to re-calibrate my panel a few times a day because my amps go to 0 and my instant salinity goes to -0.
After my third re-cal today be salt read 2800 and my instant read -3200. Is this right? Seems very off.
I check the flow switch and I found a hard white build up on the metal fin, almost like dried Elmer's glue. I couldn't pick it off with my nail so I left it in tact.
It was suggested my salt cell could be dying?
This is my third year with the Hayward T-9 cell that is wired to an Aqua Rite Goldline. The cell is clean and was stored indoors over the winter.
I hope someone can shed some light.
Thanks,
Jason
I'm having to re-calibrate my panel a few times a day because my amps go to 0 and my instant salinity goes to -0.
After my third re-cal today be salt read 2800 and my instant read -3200. Is this right? Seems very off.
I check the flow switch and I found a hard white build up on the metal fin, almost like dried Elmer's glue. I couldn't pick it off with my nail so I left it in tact.
It was suggested my salt cell could be dying?
This is my third year with the Hayward T-9 cell that is wired to an Aqua Rite Goldline. The cell is clean and was stored indoors over the winter.
I hope someone can shed some light.
Thanks,
Jason