Where my spa wall meets the pool wall, there is brown rust stains which i assume is rust from reobar. I posted on a facebook site and got a good suggestion but looking more feedback before I start fixing. See photo.
I'm in Australia so the suggestions were products supplied with AU. Suggestion was to remove the tiles around damaged spot, dig into masonry, and seal the leach area with FERROPRE epoxy. Suggestion was to also use a product called GALMET on the ipacted reo before the epoxy. Once all done, use a pool tile glue to put tiles back.
Whilst doing the repair I will need to drain water a little. How do I keep the pump running for a few days whilst the levels are low, can I simply connect my skimmer plate and hose and feed the hose from the pool if my water line is lower than skimmer box (allowing the pump to keep recirculating)?
Any help with the repair would be most appreciated.
I'm in Australia so the suggestions were products supplied with AU. Suggestion was to remove the tiles around damaged spot, dig into masonry, and seal the leach area with FERROPRE epoxy. Suggestion was to also use a product called GALMET on the ipacted reo before the epoxy. Once all done, use a pool tile glue to put tiles back.
Whilst doing the repair I will need to drain water a little. How do I keep the pump running for a few days whilst the levels are low, can I simply connect my skimmer plate and hose and feed the hose from the pool if my water line is lower than skimmer box (allowing the pump to keep recirculating)?
Any help with the repair would be most appreciated.