I've been tearing my hair out looking for a fault in my equipment because a GFCI breaker keeps tripping in my EasyTouch 8.
I finally tried connecting the breaker to other circuits, and it trips on every circuit whenever current passes through it. So I'm going to replace the breaker.
It's a 20 amp 120 volt single pole GFCI breaker, nothing special. Are there any tips & tricks for swapping a breaker in the EasyTouch load center specifically? Will it pop right out, or is there anything holding it in place? (Yes, I know to cut power first.)
I finally tried connecting the breaker to other circuits, and it trips on every circuit whenever current passes through it. So I'm going to replace the breaker.
It's a 20 amp 120 volt single pole GFCI breaker, nothing special. Are there any tips & tricks for swapping a breaker in the EasyTouch load center specifically? Will it pop right out, or is there anything holding it in place? (Yes, I know to cut power first.)