Hi, I’m a newbie here as well as to pools. I got my first pool with a house that I purchased 5 months ago. Ive learned a lot but still need A lot of help.
Pool is 13,500 gallons and has a spa. 17 years old and equipment was not maintained well as it appears they only made repairs as needed.
The motor has been overheating since the beginning and would turn on when cold and run its full course. Turned off, it would not restart until cooled down.
Now it will not run at all, only hum, so I assume its dead.
My pump is a pentair whisper flo. The motor is a Jandy 1.25 hp C55CXKTN-2127 and probably not the first one.
although I would like a VS replacement, it not in my budget at this time.
the pump services both my spa and pool. I think the 1.25 is too small but I’m not sure of that.
I also would like an easy exchange without the knowledge of programming a VS.
Can anyone recommend a replacement motor? I am confident that I can DIY the job.
My automation is Hayward And appreciate any and all help and suggestions.
Thanks.
Pool is 13,500 gallons and has a spa. 17 years old and equipment was not maintained well as it appears they only made repairs as needed.
The motor has been overheating since the beginning and would turn on when cold and run its full course. Turned off, it would not restart until cooled down.
Now it will not run at all, only hum, so I assume its dead.
My pump is a pentair whisper flo. The motor is a Jandy 1.25 hp C55CXKTN-2127 and probably not the first one.
although I would like a VS replacement, it not in my budget at this time.
the pump services both my spa and pool. I think the 1.25 is too small but I’m not sure of that.
I also would like an easy exchange without the knowledge of programming a VS.
Can anyone recommend a replacement motor? I am confident that I can DIY the job.
My automation is Hayward And appreciate any and all help and suggestions.
Thanks.