Power loss mineral springs ms-10

[Scsu74]

Hi all, hoping someone might be able to offer some guidance. Noticed my water getting cloudy and when I checked my salt unit all lights were off. I reset GFI and switches on the breaker with no luck.

I then replaced the limiter which has gone bad in the past, but that did not fix the issue. I ordered a new complete board and after installing it still didn't fix the issue.

Anyone have ideas on what else I could check? Thank you in advance.

 

[RJ-45]

That is an old version of Aquarite. Use your multimeter.

Check your input voltage, (120V or 240V）, Check the out put of transformer (around 30 V AC), Check the output out of bridge rectifier (30 V DC) those are the black and red wire connect to the upper right of the board.

 

[Scsu74]

Thank you!! Any chance the display board might be bad?