My Polaris PB4-60 doesn’t seem to be running. When I turn it on it makes no sound yet it got hot.
Shouldn’t I hear some kind of low humming.
Shouldn’t I hear some kind of low humming.
Polaris PB4-60
- Thread starter rockryan
- Start date
- Jul 21, 2013
- 66,525
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
You should hear the PB4-60 pump running.
Check the capacitor on the hump of the motor.
Post pictures of your equipment pad.
www.troublefreepool.com
Check the capacitor on the hump of the motor.
Post pictures of your equipment pad.
Pump Capacitors - Further Reading
www.troublefreepool.com
The output of my pool filter goes to the heater and to the polaris pb4-60.
It’s been working but I think it’s not ideal.
My Polaris is constantly getting water even if it’s not turned on.
How bad is this?
It’s been working but I think it’s not ideal.
My Polaris is constantly getting water even if it’s not turned on.
How bad is this?
- Jul 21, 2013
- 66,525
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Water flows through the Polaris booster pump when it is not on and is normal. It acts as another return.
Show us better pictures of the plumbing in the area of the booster pump tee pickoff.
The booster pump pickoff was not installed in the typical location in the plumbing.
Show us better pictures of the plumbing in the area of the booster pump tee pickoff.
The booster pump pickoff was not installed in the typical location in the plumbing.
- Jul 21, 2013
- 66,525
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Similar threads
