Well it's been a few years since I was back on the TFP.
Because my pool(s) have been trouble free after learning so much!
However, I have been working on my Pentair Mastertemp 400 for about a day now - between research and video's and trying to troubleshoot what's actually wrong before I start replacing parts.
Here are 3 videos of the symptoms with poor narration from me.
Clearly there is power, and there appears to be no error lights (this was taken during cold start-up).
It was working fine about a week or so ago, and there is no rodent damage.
I also peered down through the exhaust to see if there was water in the tub, it appears there isn't any (thankfully!)
I checked the Igniter and the ohms reading when cold is 87, I realize this is close to the allowable maximum.
I have not yet removed the ignitor for a visual inspection.
Hoping there are some true 'heater' whisperer's here that can give me a clue. Thanks!
Because my pool(s) have been trouble free after learning so much!
However, I have been working on my Pentair Mastertemp 400 for about a day now - between research and video's and trying to troubleshoot what's actually wrong before I start replacing parts.
Here are 3 videos of the symptoms with poor narration from me.
Clearly there is power, and there appears to be no error lights (this was taken during cold start-up).
It was working fine about a week or so ago, and there is no rodent damage.
I also peered down through the exhaust to see if there was water in the tub, it appears there isn't any (thankfully!)
I checked the Igniter and the ohms reading when cold is 87, I realize this is close to the allowable maximum.
I have not yet removed the ignitor for a visual inspection.
Hoping there are some true 'heater' whisperer's here that can give me a clue. Thanks!