Heater installed last fall, trying to turn it on for the first time this season. I have been googling error messages like crazy so I'm just going to tell you everything as much of it seems to be user error as I learn how to use it.
Heater starts off with ERR PS, have to turn up my pump to get the pressure high enough. After that, ERR AFS. I feel the fan going on a very low RPM... and it takes a good 5-10 minutes to ramp up and make this error go away. Not sure why it takes so long but it does so on its own (normal?).
After that I get ERR IGN. The heating light will flash, I'll hear it trying to fire up 3 times (light temporarily goes solid before flashing again). I have two gas valves, one at heater and one at meter, and both are open. I attached a picture of what I think is making the noise when it tries to light... that thing on the bottom right looks cock-eyed to me but I know better than to touch something with multiple DANGER stickers lol.
One single time ERR IGN changed to ERR AGS, which was stuck until I power cycled per Google instructions.
Is there anything I can do or look at before making a service call?
Heater starts off with ERR PS, have to turn up my pump to get the pressure high enough. After that, ERR AFS. I feel the fan going on a very low RPM... and it takes a good 5-10 minutes to ramp up and make this error go away. Not sure why it takes so long but it does so on its own (normal?).
After that I get ERR IGN. The heating light will flash, I'll hear it trying to fire up 3 times (light temporarily goes solid before flashing again). I have two gas valves, one at heater and one at meter, and both are open. I attached a picture of what I think is making the noise when it tries to light... that thing on the bottom right looks cock-eyed to me but I know better than to touch something with multiple DANGER stickers lol.
One single time ERR IGN changed to ERR AGS, which was stuck until I power cycled per Google instructions.
Is there anything I can do or look at before making a service call?