I have an Intellitouch4 that I manage with the Screenlogic App on iOS.
I have "Pool" and "High Speed"... Pool is something like 1900rpm and High Speed is around 2800. Because my equipment is 6 feet above the pool and there is a mystery vacuum leak, I have to run POOL mode 24/7 and want HIGH mode to kick in twice during the day for filtration reasons.
Also, I do not want to make a bunch of sequential schedule entries, I just want the 24/7 POOL setting and then just change the HIGH settings as an overlap as needed for use/season/weather.
I've attached a screenshot of my schedules. It will run POOL 24/7... but it is not kicking into HIGH at all... the time comes and goes and nothing happens. It used to work but I had to redo the programming, and thought I did it the same as before... but clearly something is wrong and I can't figure it out.
Notice in the picture... it is 2:16PM and the 2:00-4:00pm HIGH SPEED is not running.
Any ideas how to get it to do what I want? TIA!
I have "Pool" and "High Speed"... Pool is something like 1900rpm and High Speed is around 2800. Because my equipment is 6 feet above the pool and there is a mystery vacuum leak, I have to run POOL mode 24/7 and want HIGH mode to kick in twice during the day for filtration reasons.
Also, I do not want to make a bunch of sequential schedule entries, I just want the 24/7 POOL setting and then just change the HIGH settings as an overlap as needed for use/season/weather.
I've attached a screenshot of my schedules. It will run POOL 24/7... but it is not kicking into HIGH at all... the time comes and goes and nothing happens. It used to work but I had to redo the programming, and thought I did it the same as before... but clearly something is wrong and I can't figure it out.
Notice in the picture... it is 2:16PM and the 2:00-4:00pm HIGH SPEED is not running.
Any ideas how to get it to do what I want? TIA!