Out put lights won’t stay on the SWG

[Chrisplus4]

Checked my chemicals and no chlorine for the 2nd week in a row. Found that the output lights won’t stay on. Is there a trick to get this thing to produce chlorine? Just added tabs for now until I get this thing figured out.

 

[mknauss]

What is the settings you have in the Intellicenter?

 

[pjt]

Do you have it connected to IntelliCenter? If so, is it correctly setup and programmed?

 

[ajw22]

Is the IntelliChlor connected to your IntelliCenter?

What % output is set for POOL mode and SPA mode?

 

[Chrisplus4]

 

[ajw22]

Are you in POOL mode or SPA mode.

Post a pic of your Home Screen.

 

[mknauss]

What is the output set for the Pool Mode?

 

[Chrisplus4]

Just saw this

 

[Chrisplus4]

 

[ajw22]

What is the output set for the Pool Mode?

Both should be on the same page.

The configuration is wrong and the SWG is not setup for the pool.

 

[Chrisplus4]

The “lost communication”. Goes out once I turn the pumps on

 

[Chrisplus4]

I can’t find the output for pool mode only spa mode

 

[Chrisplus4]

Both should be on the same page.

The configuration is wrong and the SWG is not setup for the pool.

How do I fix that?

 

[Chrisplus4]

Figured it out! Thanks for your help!

 

[mknauss]

The “lost communication”. Goes out once I turn the pumps on

Your pumps are likely wired to the Load side of your relay. They should have power all the time. Check that.

 

[ajw22]

Your pumps are likely wired to the Load side of your relay. They should have power all the time. Check that.

Not necessarily. The IntelliChlor is wired to the LOAD side of the filter pump relay. When the pump is off the IntelliChlor is shutdown and the IntelliCenter sees that as lost communication.

 

[mknauss]

OK --