Hi all-
We have the Omni hub automation that comes with the VS Hayward pump. We’ve been able to control quite a lot of automation with that little system and so far are pleased.
However, the one thing I can’t seem to figure out is IF it can be programmed for a spillover mode. We currently have pool mode and spa mode only. (two actuators controlled, one on suction side/one on return side) The builder installed a bypass with a manual valve to circulate the spa water when in pool mode. That means we always have a small trickle of spillover running at all times. With our recent addition of a SWG-I’d like to have the option to not increase the pH as much.
I’ve read the manuals and can’t seem to find how to set this up, but the Omni hub manual does mention spillover is possible if configured.
Anyone know how to configure the actuators in the Omni hub system? It’s got to be somewhere in the advanced config settings. Right now they turn together, seems like if I can just turn the return to spa and save it that would be a “spillover” mode. Then I can close the bypass altogether.
Thanks for any help!
We have the Omni hub automation that comes with the VS Hayward pump. We’ve been able to control quite a lot of automation with that little system and so far are pleased.
However, the one thing I can’t seem to figure out is IF it can be programmed for a spillover mode. We currently have pool mode and spa mode only. (two actuators controlled, one on suction side/one on return side) The builder installed a bypass with a manual valve to circulate the spa water when in pool mode. That means we always have a small trickle of spillover running at all times. With our recent addition of a SWG-I’d like to have the option to not increase the pH as much.
I’ve read the manuals and can’t seem to find how to set this up, but the Omni hub manual does mention spillover is possible if configured.
Anyone know how to configure the actuators in the Omni hub system? It’s got to be somewhere in the advanced config settings. Right now they turn together, seems like if I can just turn the return to spa and save it that would be a “spillover” mode. Then I can close the bypass altogether.
Thanks for any help!