Hayward/Goldline/Aquarite salt system
11000 gallon pool
I have a green pool virtually overnight. I checked the system, and it's showing "Inspect Cell", "Check Salt", and no generation. I cannot get the Inspect Cell to go off, even after repeatedly holding down the diagnostic button for 5-10 seconds. The system is showing the following:
2100 Salt Level
Diagnostic readings are
82
32.4
0.00
69P
-0
AL-0
R 1.32
I checked the salt level twice with two different Taylor K-1766 kits (in case the chemical was bad in the older one). Salt checks at 3000 and 3200. And I have added salt recently, so that seems about right.
I also cleaned the cell with water and muriatic acid. No difference.
I've never had the "inspect cell" light not go off.
The cell is a third party cell about 18 months old.
11000 gallon pool
I have a green pool virtually overnight. I checked the system, and it's showing "Inspect Cell", "Check Salt", and no generation. I cannot get the Inspect Cell to go off, even after repeatedly holding down the diagnostic button for 5-10 seconds. The system is showing the following:
2100 Salt Level
Diagnostic readings are
82
32.4
0.00
69P
-0
AL-0
R 1.32
I checked the salt level twice with two different Taylor K-1766 kits (in case the chemical was bad in the older one). Salt checks at 3000 and 3200. And I have added salt recently, so that seems about right.
I also cleaned the cell with water and muriatic acid. No difference.
I've never had the "inspect cell" light not go off.
The cell is a third party cell about 18 months old.