Need help identifying spa jets

Jump to latest Follow Reply
E

eublet

0
Gold Supporter
May 24, 2016
57
Mobile, AL
I've spent at least two hours searching the internet trying to figure out what part this is, but can't. I have 6 jet in my spillover spa. One of them is missing a directional eyeball and retainer. Pictures below are one of the eyes with and without the insert, along with a picture of the eyeball/retainer insert itself. Inside is 4" non-threaded venturi nozzle. I've found a few things that look similar to this but nothing close enough. Mine has two little tab on each side of the retainer ring for tightening it in. Any body know where I could start looking? I've been scouring spa parts stores for images and just can't find anything. Many thanks in advance!

1588026456224.png

1588026480875.png

1588026506054.png
 

Attachments

  • 1588026456890.png
    1588026456890.png
    977 KB · Views: 1
@RDspaguy @kadavis @jimmythegreek ideas on the part?

If these guys don't have a clue then send the pice to

Inyo Pools: Your Destination for Pool Equipment & Parts - INYOPools.com

Discover a vast selection of high-quality pool supplies, equipment, and accessories at Inyo Pools. From pumps to filters, heaters to cleaners, pool accessories to hard to find parts. Over 70,000 products available. Backed by 100k 5-Star customer reviews, hassle-free returns, expert advice and...
www.inyopools.com www.inyopools.com

@InyoRob
 
I have emailed pictures to Inyo so maybe they will know as well. I've scowered all the old parts diagrams for Hydro Air and can't see anything that looks like mine. Close, but no cigar. Also older Balboa parts but nothing matches either.
 
Yeah, I thought it was a 3.5" face. Some of the hydroair jets have that hexagonal fitting in the back of the jet that can be seen in your pic, but the nozzle and ring don't match up. They also have inserts that slide into the jet body and engage that hex at the back, allowing the jet to be adjusted. Those inserts may have a removeable nozzle, I can't find a detail on them that shows it, but it doesn't look like those either. See what inyo says, if they can't find it I will see what else I can find.
 
@RDspaguy Inyo hasn't responded so I'm not feeling good about it. Are you saying that maybe the parts that are in my spa don't necessarily go together? Any suggestions on what I can do to fix this? Maybe a way to swap out more internals or something? I have 3 7/8" twistlock venturi nozzles inside those jets. I did a lot of digging and Hydro Air and Balboa have both use those types of nozzles, but it doesn't look like they are a match. I found one company that makes a "mini jet" that lists the diameter of the retainer ring the same as mine, but the tabs are different and the eyeball itself has a longer nozzle on it.
 

Enjoying this content?

Support TFP with a donation.

Give Support
You must log in or register to reply here.
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Top Bottom
Back
Jump to latest Follow Reply