I have been trying to get my Jandy LXI 400 (propane) working for the last year and a half and still no luck. Here is the latest:
Blower comes on, I hear the 3 clicks, I smell propane, nothing ignites, get “Ignition Lockout” error. So far I have:
1) replaced flame sensor
2) replaced ignighter
3) replaced gas valve
4) replaced Fenwell control module
5) checked hoses to air pressure switch for cracks
6) checked air pressure switch with multimeter
7) checked propane level in main tank
8) removed small visible amount of corrosion on the Universal Controller Power Interface
9) Had an HVAC guy out and he attempted to bypass the Air Pressure Switch to see if it would ignite and it would not
Next step:
1) Replace the Air Pressure Switch?
Looking at old threads, two other options are:
1) check gas with manometer even though we clearly smell propane
2) clean off “2 spade connectors”, but I am not sure where or what these are
Any other suggestions?
Blower comes on, I hear the 3 clicks, I smell propane, nothing ignites, get “Ignition Lockout” error. So far I have:
1) replaced flame sensor
2) replaced ignighter
3) replaced gas valve
4) replaced Fenwell control module
5) checked hoses to air pressure switch for cracks
6) checked air pressure switch with multimeter
7) checked propane level in main tank
8) removed small visible amount of corrosion on the Universal Controller Power Interface
9) Had an HVAC guy out and he attempted to bypass the Air Pressure Switch to see if it would ignite and it would not
Next step:
1) Replace the Air Pressure Switch?
Looking at old threads, two other options are:
1) check gas with manometer even though we clearly smell propane
2) clean off “2 spade connectors”, but I am not sure where or what these are
Any other suggestions?