I just did a partial drain and fill of about 5500 gallons in my 20000 gallon in-ground pool, and my water guy pointed out that the liner was pulling back on three corners. After draining I had just over 1.5 ft in the shallow end. Can this be saved or do I need a new liner?
Liner pulling back - can I save it
- Thread starter StonkyMcStonksky
- Start date
- Jul 21, 2013
- 65,127
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
How old is your liner?
Everyone needs a new liner eventually.
Do you have liner lock installed?
It is very difficult to work a liner back into corners with water in the pool.
Everyone needs a new liner eventually.
Do you have liner lock installed?
It is very difficult to work a liner back into corners with water in the pool.
I believe the liner is about 5 years old. I’m not even sure what liner lock is yet - we just bought the house.
Could this have been due to my drain and fill? I never noticed it before, but I never really knew to look.
- Jul 21, 2013
- 65,127
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
I think the corners were like that when you bought the house.
You will fix it when you replace the liner.
Liner lock is explained at the bottom of Liner Replacement - Further Reading
You will fix it when you replace the liner.
Liner lock is explained at the bottom of Liner Replacement - Further Reading