C,
If you look inside the door to your EasyTouch there is a large decal that shows the
name of each relay... The whole point of naming each relay is so that later on, if someone whats to change or add something, they know where each relay should be... Unfortunately, your installer did not use that location decal, so now he is the only one that knows which relay is which. Before you can wire something new, we need to determine what the name of each relay is now.
As designed, the sequence should be as follows..
P/F, Aux 1, Aux 2, Aux 3
Aux 4, Aux 5, Aux 6, Aux 7..
I suspect your panel is wired like this...
P/F, Aux 1, Aux 2, Aux ??
Aux ??, Aux ?? Aux 3, Aux 4
We need to confirm this and to figure out the missing three relays.
I know it is a pain, but you need to drop the main panel down and then follow the wires from each relay up to where they connect to the main board..
Show me a pic of your current set up, like the one below...
In theory every relay should be plugged in even if the relay is not being used.
Thanks,
Jim R.