Just another T-15 end of life story?

drummerman951

Silver Supporter
Apr 6, 2019
107
Riverside, CA
Pool Size
22000
Surface
Plaster
Chlorine
Salt Water Generator
SWG Type
Hayward Aqua Rite (T-15)
I guess it had to happen eventually... it seems like Hayward T-15 is dying. Unit states "Low Salt", but when checked via 1766 testing shows 4600ppm. Shame on me for just adding bags of salt without recognizing a problem immediately. I replaced my cartridges (unrelated, it was time after 5yrs) today and cleaned SWG as well. No change. Diagnostic on positive side shows 1000-1500ppm, but negative side is 2800ppm. My FC looks good still, but I'm concerned that SWG may not run when needed. So I changed it to a T-9 in settings, increased operating % and now its 4100ppm. With the 500ppm Hayward tolerance, I think I may get a little more out of this cell operating as a T-9.... its a little over 5 years old. Installed with new pool in July 2018.

Any feedback or suggestions why I should not go in this direction, please let me know.
Thanks!
 
its a little over 5 years old. Installed with new pool in July 2018.
You have long SoCal seasons and a bunch if gallons to treat. If this is the end, that li'l fella did right by you. Squeeze what you can out of it and thank him for his service. :salut:
 
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.