My IC60 has been giving a cold water stop light for a few days now. The light was on this morning, and then when I checked about 5 hours later the IC60 was back to generating Chlorine! I thought that when the unit powered up in the morning, it detected cold water and stopped until the next power up cycle or 12 hours. Apparently that is not the case. My system is only running 6 hours a day now, from 10am to 4pm. Seems like the unit is monitoring water temp continously, and when the temp goes above the threshold it will initiate another boot up and run as normal.
I was going to take my IC60 out of the system and install my bypass tube. My winter water temp just hovers around the low 50's so I will let the SWG do its thing for a while. Might be that if I change my schedule to start and finish later in the day I could get some more on time.
No biggie, but I have not seen this mentioned before so I thought I would.
Gary
I was going to take my IC60 out of the system and install my bypass tube. My winter water temp just hovers around the low 50's so I will let the SWG do its thing for a while. Might be that if I change my schedule to start and finish later in the day I could get some more on time.
No biggie, but I have not seen this mentioned before so I thought I would.
Gary