All, My Jandy remote (model: R0687300) recently stopped working, it would not go past "waiting" (image1) when I power it on. I followed the instructions in the troubleshooting section to reset the remote, it states "Turn off power to the system. Disconnect battery at the Power Center and turn on power. Reconnect the battery and reset time and date." I assume it is referring to the 9v at the control box, but mine does not have one (image2). I went ahead and turned off the main power to equipment, and switched back on but was never prompted to reset date/time. So This did not work, I then searched here and a thread from a number years ago someone recommend to change the channel it uses. I tried this procedure but it just hangs on the "slide switch to learn mode" (image3) .. Any feedback on what I may be doing wrong or alternate ideas to get remote back on line is much appreciated. Thanks!!
