My LXiheater works but the internal water temp indication on the control panel starts at 70 then rapidly runs up to 104 which is the max set temp limit and shuts off the burners. To get them back on I can shut off circuit breakers, then reset and the indicated temp resets to 80 and the burners come back on. After an hour or so the temp indication builds back up to 104 and shuts off the burners again. I can repeat this cycle to get my pool up to swimming temp...It acts like a bad temp sensor to me ...any suggestions?
Jandy LXiheater
- Thread starter Bugs
- Start date
- May 3, 2014
- 58,391
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
Incorrect temp reading on Jandy LX heater...HELP!
Hi, I have a 12 year old Jandy LX heater and have had very good luck with it until recently. When I fired it up for the first time this year, the temperature reading was 84 degrees Fahrenheit. I could tell it was wrong by putting my foot in the pool so I checked the floating thermometer and it...
www.troublefreepool.com
Welcome to the forum!
I suggest you read ABC's of Pool Water Chemistry and consider reviewing the entire Pool School eBook.
- Jun 7, 2017
- 9,058
- Pool Size
- 29000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Jandy Aquapure 1400
