My Jandy Lite 2 heater fires up, runs about 25 sec., restarts after about 1 min. then keeps repeating. Nat. gas / 240v unit
jandy lite 2
- Thread starter rclassen
- Start date
flashes FL 0 Have tested temp sensor, 7.8ohms @ 87degrees, pressure switch has continuity, syphon tube has water pressure
- Jul 21, 2013
- 65,473
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Welcome to TFP.
Is your lite 2 Model LD, LG, or LJ?
Likely a dirty filter causing low water flow. When did you last clean your filter?
Other causes of FL0…
Is your lite 2 Model LD, LG, or LJ?
Likely a dirty filter causing low water flow. When did you last clean your filter?
Other causes of FL0…
Similar threads
