Hello there, I'm getting Service error code 175 and 182 on my Jandy Aqualink system. I have a the Jandy Aquapure PLC 1400 cell which is new as of this season. When i installed the new SWG I kept using the existing try-sensor as it worked fine, and the pool has been running that way for several months. I started getting error code 175 and 182 more than a week ago and I tried cleaning the sensor with a green scotch bright pad but no luck. Figuring the sensor was bad (I've replaced these several times already), I then installed the new tri-sensor which came with the PLC1400 unit. To my surprise, the new sensor made no difference and I still get the same error codes. The flow indicator is on but the cell is not. I tested the pool water manually so I know the salt level is 2800. When I look at the computer readout of the salt level, sometimes its 0 and sometimes its "12750". I would appreciate any advice on troubleshooting this further.
thank you.
Paul
thank you.
Paul