Hi, My Jandy Aquapure is less than 2 years old. My PDA just stopped showing the water temperature (but the main board shows 78), and my aquapure stopped creating chlorine. I have increased it to 60% on my PDA, but it's showing 00% on the main board. The "flow" button is lit but not the "cell on" button. My pool got down to no chlorine so I ran the Boost from the PDA and it worked great. I also put the main board into service mode and was able to set the chlorine to 30% and the cell turned on no problem. Hoping it's something simple you might be able to help me with!
Jandy Aquapure - no Temp reading on PDA and cell won't turn on, but works in service mode
- Thread starter VWood
- Start date
- Jul 21, 2013
- 53,111
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
- Jun 7, 2017
- 9,153
- Pool Size
- 29000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Jandy Aquapure 1400
Oceansol
Well-known member
Poolgate, i just had my aquapure 1400 replaced and now the in-the-house controller is frozen with FIRMWARE B12 only showing. Can you help me?