Jandy Aqualink Update?

[JayVal]

Pictured are the current Aqualink products on my system. I upgraded to the VS pump a few years ago, and now I want to be able to control my equipment via WiFi/App.
The more I read and research, the more confusing it gets. So, based on what I currently have, which Upgrade Kit do I need.
Note: the one touch controller in the pic just died last week.
I also have a spa connected to the pool, solar plumbing, and water feature. I appreciate any guidance in figuring this out.
Thanks

 

[ajw22]

Welcome to TFP.

You can check your system Rev level but it looks like you are not up to Rev R which is required for iAqualink.

You need the IQ30-RS upgrade kit which will replace your board and give you the antenna.

Jandy Aqualink RS - Further Reading

www.troublefreepool.com

Jandy iAquaLink 3.0 Web Connect Device

#IQ30-RS iAquaLink Web Connect Device Kit

www.tcpoolequipment.com

 

[JayVal]

Thanks for your reply. Much appreciated. But, before I go any deeper, I just want to make sure I’m looking at the correct device for the Rev. number. Do I need to look on the board in the panel outside, or would that be the same as the Rev. I’m seeing on the One-Touch Control device. Rev. B11 is what I see on the one touch wireless device. I haven’t looked at the board mounted in the control panel outside yet, but will do that now.

 

[ajw22]

If you have the Aqualink OneTouch Panel then MENU/SELECT(press SELECT) -> SELECT (for HELP) -> DIAGNOSTICS (press SELECT).

Jandy Aqualink RS - Further Reading

www.troublefreepool.com

 

[JayVal]

Based on your direction, screen says Firmware L.

 

[ajw22]

Based on your direction, screen says Firmware L.

You have an old board and need IQ-30RS upgrade.

 

[JayVal]

Thanks for your input. That’s what I will order.