This might be a silly question? But why do you want to remove the sight glass?
I took a quick look at my intex 16” sand filter and as near as I can tell the sight glass is just screwed in. I didn’t actually try to remove mine, because, well, I want it to remain where it is. But if yours is anything like mine I believe that you should just be able to unscrew it.
Thank you Brett
i want to remove as i am in the process of resetting up my pool and it has algae inside and did nt want to start season that way.
Again thank you
I wouldn’t worry about algae inside the sight glass too much because water only goes through the sight glass when you are backwashing or sending water to waste... and any water the passes through the sight glass is not put back into the pool.
It just screws off. Use a cloth wrapped around it so it doesn't scratch, and some channel lock pliers. But, that water goes out, not in. It does make it hard to see if the water is clear, though, when you backwash.
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Welcome to TFP! For a wealth of pool care information please check out our free Pool School. If you are in need of specific help then we encourage you to Register and ask us here in the forum!