Hi,
I was trying to get a little more pressure in the jets of my SPA, but the pump shuts down after a few seconds if I set the rpm much above 3000. It should go to 3450. I thought maybe the pressure got high due to obstructed flow in SPA mode, but it shuts down at these rpm's even in POOL mode. If I monitor power and current it doesn't seem to come anywhere near the pumps max ratings. It is controlled by a Screenlogic system, not controls on the pump in case that matters.
Any ideas on why it may be shutting down?
Paul
I was trying to get a little more pressure in the jets of my SPA, but the pump shuts down after a few seconds if I set the rpm much above 3000. It should go to 3450. I thought maybe the pressure got high due to obstructed flow in SPA mode, but it shuts down at these rpm's even in POOL mode. If I monitor power and current it doesn't seem to come anywhere near the pumps max ratings. It is controlled by a Screenlogic system, not controls on the pump in case that matters.
Any ideas on why it may be shutting down?
Paul