Intellichlor no lights and com error on easytouch.

[Rmiller2]

I recently soaked my intellichlor in acid solution and now I have no lights and error com message on my easytoch screen. Does anyone have any insight as my best trouble shooting steps?

Thanks

Rich in Clearwater FL

 

[mknauss]

Welcome to the forum!
That condition typically means you have an issue with the cord from the ET to the SWCG. Check the connection.
Also, check the small circuit breaker in the upper right of the ET panel that says Intellichlor.
I suggest you read ABC's of Pool Water Chemistry.

 

[Jimrahbe]

Rich,

Either you forgot to plug your IC40 back into the EasyTouch, your pump filter relay is not closed (Service mode), or your SWCG power supply card had gone South.

Thanks,

Jim R.