Hey sorry about the late response so I got it going. I have another small issue idk if you know anything about chillers but now I’m trying to my AquaCal Tropicool with the Intellicenter and that won’t communicate. I have the rs485 connected green and yellow on Intellicenter and green and yellow on chiller and have already set chiller to smart mode and Intellicenter to ultra temp and enabled cool. Just keep getting a *smart comm fault* at chiller. Any ideas?
IntelliCenter WiFi issue
- Thread starter Landrade2016
- Start date
- Jul 21, 2013
- 65,165
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
What IntelliCenter firmware release are you running?
Have you read Pentair Automation Systems - Further Reading
Have you read Pentair Automation Systems - Further Reading
On the chiller I have a 5 button press not the slide version is still compatible?The only thing I don’t have is the 10 ohm sensor connected will that cause that fault?
- Jul 21, 2013
- 65,165
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
I don't think you have the correct control panel to make it work.
Call Aquacal and see what they say.
You may need to have a 10K resistor connected to the Solar Sensor but lack of it will not cause the COMM problem.
Similar threads
