1st post, so hi to everyone. Thanks for any input and advice. Now onto the issue...
16x42' fiberglass pool installed last summer. No issues. Several storms blew through the TN area recently and our 200# grill was blown by the wind approx 15' away, over pavers, onto the cover and dumped into the pool. Grill was removed and the cover was pulled back to inspect for damages. Water level was down and paver damage down both long sides (42') was observed. Initital thought was that the grill damaged/cracked the pool shell, water leaked down, earth pressure pushed in and sides bulged in. Now the pool wasn't empty but the level had dropped to about 2 inches below the jets. Pool installation company was notified and they said to add water back to the pool. They made 2 or 3 trips out to inspect. Insurance company was called, adjuster came, engineer came, leak detection company came. Still waiting on the full report. Leaks had apparently came from broken seals around jets, lights, etc... when the walls bulged, it caused this. Otherwise no leaks detected, no cracks or defects. I feel as though its going to turn into a finger pointing match between my homeowners insurance, the installers insurance and the pool manufacturers insurance companies. So any thoughts on what caused the bulge?
I've been told several possibilities. Still waiting on the engineers findings. I have my own opinions. I don't want to sway the comments but would to hear opinions on possible causes.
Plan is to remove the pavers, hand dig the gravel out and hopefully let the sides re expand and then put it all back. Hopefully better than it was so this doesn't happen again...but again, what caused it to begin with so that it doesn't reoccur?
16x42' fiberglass pool installed last summer. No issues. Several storms blew through the TN area recently and our 200# grill was blown by the wind approx 15' away, over pavers, onto the cover and dumped into the pool. Grill was removed and the cover was pulled back to inspect for damages. Water level was down and paver damage down both long sides (42') was observed. Initital thought was that the grill damaged/cracked the pool shell, water leaked down, earth pressure pushed in and sides bulged in. Now the pool wasn't empty but the level had dropped to about 2 inches below the jets. Pool installation company was notified and they said to add water back to the pool. They made 2 or 3 trips out to inspect. Insurance company was called, adjuster came, engineer came, leak detection company came. Still waiting on the full report. Leaks had apparently came from broken seals around jets, lights, etc... when the walls bulged, it caused this. Otherwise no leaks detected, no cracks or defects. I feel as though its going to turn into a finger pointing match between my homeowners insurance, the installers insurance and the pool manufacturers insurance companies. So any thoughts on what caused the bulge?
I've been told several possibilities. Still waiting on the engineers findings. I have my own opinions. I don't want to sway the comments but would to hear opinions on possible causes.
Plan is to remove the pavers, hand dig the gravel out and hopefully let the sides re expand and then put it all back. Hopefully better than it was so this doesn't happen again...but again, what caused it to begin with so that it doesn't reoccur?
Last edited by a moderator:
